Straightener

STS Straightener Machine

Features introduction:

1. Due to the different curvature of each point of the material, a single straightening roll arrangement cannot meet the requirements of high-precision straightening. Large rolls are used for rough straightening, small rolls for fine straightening, and different straightening concepts are used. Coarse straightening is used. Make the material roll produce a single curved arc and then correct it with fine correction to meet the requirements of customers' stamping use.

2. The leveling wheel and straightening auxiliary wheel of this machine are all made of imported SUJ2 and heat treated with HRC60. Post-grinding, then hard chrome plating and post-grinding to ensure uniform hard chrome layer and shape tolerance of each shaft.

3. The machine uses worm gear and worm synchronous pressing mechanism for rough leveling, with a dial indicator, which can quickly find the leveling point.

4. The fine leveling adjustment of this machine adopts a floating four-point balance fine-tuning device, with a dial indicator, which can quickly find the leveling point.

5. The machine adopts universal joint transmission and gear full transmission, which is suitable for products with high straightening accuracy requirements.

6. In addition to the straightening roll, the addition of the guide wheel produces a rolling effect on the material to further improve the accuracy.

7. The whole machine adopts high-precision bearings and is equipped with a lubrication system to prolong the service life.

8. Each straightening wheel of the S series precision straightening machine is equipped with a leveling auxiliary wheel to ensure that it will not be bent and deformed during the production process, thereby improving the flatness quality of the product.

9. The upper and lower auxiliary rollers are fixed, which improves the rigidity of the upper and lower wheels and prevents deformation under force.

10. Due to the difference in material, material width and material thickness, there is no uniform numerical reference. Therefore, it is